I've attached a diagram to help visualize what I'm looking for. I was wondering if there was a way to configure multiple Fios routers to run off the houses coax? Our home is a bit too big for a single Fios router, and a few too many devices. No configuration needed as it pulls all the settings from the main Verizon router. It really just plugs into coax and starts working. Now, if the OP doesn't have any extra hardware beyond the useless-on-FiOS cable modem and a Linksys router, the WCB3000N is a great way to go. If you can't find them, just say so and I'll post some links. There are some good posts over on that describe how to do this. If the OP has an extra Actiontec router and isn't afraid of a mucking around in the configuration menus, then this is a good route to follow. While not that complicated, there are a specific set of configuration steps that must be followed in a specific order to get it working properly. It needs to be configured into bridge mode. This is fine if all you want is Internet access, but prevents sharing of important things like printers, scanners and storage.Īn Actiontec router can be used as a network extender. The approach listed in this article will create a double NAT, which means devices attached to the 2nd router will not be able to access resources connected to the first router. Whenever I see an article that insists on calling FiOS router's modems, I know that the author doesn't fully understand the system. First of all, FiOS doesn't use modems, only routers. The instructions on the "smalbusiness" site aren't that good.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |